ISO-20753 › Plastics - Test specimens
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies dimensional requirements relating to test specimens prepared from plastics materials intended for processing by moulding, as well as to test specimens prepared by machining from sheets or shaped articles. It compiles the designations and dimensions of test specimens used for the acquisition of comparable data and of other frequently used specimens.
The following types of test specimen are specified:
A Tensile specimen, multipurpose or reduced-scale
B Bar specimen
C Small tensile specimen
D Square plate specimen
F Rectangular plate specimen
NOTE If a particular type of test specimen is not mentioned in this document, this does not mean that there is any intention to exclude the use of the specimen. Additional specimen types can be added in future if they are commonly used.
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 20753:2023
Revision Level
3RD EDITION
Status
Current
Publication Date
Nov. 1, 2023
Committee Number
ISO/TC 61/SC 2