ISO-21561-2 › Styrene-butadiene rubber (SBR) - Determination of the microstructure of solution-polymerized SBR - Part 2: FTIR with ATR method
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 21561-2:2016 specifies procedures for the quantitative determination of the microstructure of the butadiene and the content of styrene in solution-polymerized SBR (S-SBR) by Fourier Transform Infrared Spectrometry (FTIR) with Attenuated Total Reflection (ATR) method. The styrene content is expressed in mass % relative to the whole polymer. The vinyl, trans and cis contents are expressed in mol % relative to the butadiene content. This method is only applicable to raw rubbers.
NOTE 1 Precision as shown in Annex A may not be obtained for S-SBRs containing polystyrene block or styrene content more than 45 mass %.
NOTE 2 Only "vinyl", "trans" and "cis", are used in this part of ISO 21561. However, the expression of vinyl, trans and cis mean as follows in general:
- vinyl: vinyl unit, vinyl bond, 1,2-unit, 1,2-bond, 1,2-vinyl-unit or 1,2-vinyl-bond;
- trans: 1,4-trans unit, 1,4-trans bond, trans-1,4 unit or trans1,4 bond;
- cis: 1,4-cis unit, 1,4-cis bond, cis-1,4 unit or cis-1,4 bond.
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 21561-2:2016
Revision Level
1ST EDITION
Status
Current
Publication Date
March 1, 2016
Committee Number
ISO/TC 45/SC 3