ISO-22407 › Metallic materials - Fatigue testing - Axial plane bending method
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the conditions for conducting the plane bending fatigue test on an axial machine, constant-amplitude, force or displacement controlled, at room temperature (ideally between 10 °C and 35 °C) on metallic specimens, without deliberately introduced stress concentrations. This document does not include the reversed/partially loading test. The purpose of the test is to provide relevant results, such as the relation between applied stress and number of cycles to failure for a given material condition, expressed by hardness and microstructure, at various stress ratios.
Although the shape, preparation and testing of specimens of rectangular and bevelled cross-section are specified, component testing and other specialized forms of testing are not included in this document.
Fatigue tests on notched specimens are not covered by this document since the shape and size of notched test pieces have not been specified in any standard so far. Guidelines are given in Annex A. However, the fatigue-test procedures described in this document can be used for testing such notched specimens.
It is possible for the results of a fatigue test to be affected by atmospheric conditions. Where controlled conditions are required, ISO 554:1976, 2.1 applies.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 22407:2021
Revision Level
1ST EDITION
Status
Current
Publication Date
May 1, 2021
Committee Number
ISO/TC 164/SC 4