ISO-237 › Rotating tools with parallel shanks - Diameters of shanks and sizes of driving squares
ISO-237
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Applies to reamers, screwing taps, etc. It comprise two series of dimensions. The complete range of diameters is divided into a certain number of diameter steps. In the metric tables, the values of the across flats of the squares and the preferred diameters are scaled in accordance with the R20 series of preferred numbers. In the inch tables, these values are exact conversions of the corresponding metric values.
To find similar documents by classification:
25.100.01 (Cutting tools in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 237:1975
Revision Level
1ST EDITION
Status
Current
Publication Date
Feb. 1, 1975
Committee Number
ISO TC 29