ISO-2507-1 › Thermoplastics pipes and fittings -- Vicat softening temperature -- Part 1: General test method
ISO-2507-1
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 2507-1:1995
Revision Level
1ST EDITION
Status
Current
Publication Date
Feb. 15, 1995
Committee Number
ISO TC 138/SC 5