ISO-2804 › Wire, bar or tube drawing dies - As-sintered pellets of hardmetal (carbide) - Dimensions
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Lays down a series of outside diameters, a range of bore sizes and certain internal dimensions with their tolerances, for as-sintered pellets of hardmetal, used as wire, bar and tube drawing dies.
To find similar documents by classification:
25.120.20 (Rolling, extruding and drawing equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 2804:1996
Revision Level
2ND EDITION
Status
Current
Publication Date
Dec. 15, 1996
Committee Number
ISO TC 29