ISO-28941-1 › Plastics - Poly(phenylene ether) (PPE) moulding and extrusion materials - Part 1: Designation system and basis for specifications
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 28941-1:2008 establishes a system of designation for PPE thermoplastic materials, which may be used as the basis for specifications.
The types of PPE plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties
- temperature of deflection under load
- melt volume-flow rate
- Charpy notched impact strength
- flammability
and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
ISO 28941-1 is applicable to all PPE materials, including those modified with polystyrene or polyamide or other materials.
It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 28941-1:2008
Revision Level
1ST EDITION
Status
Current
Publication Date
Dec. 15, 2008
Committee Number
ISO/TC 61/SC 9