ISO-295 › Plastics - Compression moulding of test specimens of thermosetting materials
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 295:2004 establishes the general principles and lays down the procedure to prepare test specimens of heat- and pressure-moulded thermosetting material from different moulding compounds, specifies the details for test specimen preparation to be included with the test reports on properties and gives the general principles for the design of the mould intended for the preparation of the test specimens. The method applies to phenolic resin, aminoplastic, melamine/phenol, epoxy and unsaturated polyester-based thermosetting powder moulding compounds (PMCs). Special methods for preparing test specimens required because of the nature of certain moulding compounds, their flow properties or other variable factors, are not considered.
To find similar documents by classification:
83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 295:2004
Revision Level
3RD EDITION
Status
Current
Publication Date
Feb. 1, 2004
Committee Number
ISO/TC 61/SC 12