ISO-2974 › Diesel engines - 60° female cones for high-pressure fuel injection components
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 2974:2018 specifies the dimensional requirements of end-connections for high-pressure fuel injection equipment components, used on diesel (compression-ignition) engines.
ISO 2974:2018 is applicable to externally threaded 60° female cones (see Figures 1, 2, 5, and 6) and intended for use with high-pressure fuel injection pipe assemblies with tube outside diameters of:
- up to and including 12 mm for integral female cones (see Table 1); and
- up to and including 9 mm for fabricated female cones (see Table 2).
Details of the pipe connection ends referenced in this document are shown in ISO 13296.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ISO-8535-1Diesel engines - Steel tubes for high-pressure fuel injection pipes - Part 1: Requirements for seamless cold-drawn single-wall tubes
ISO-13296
Diesel engines - High-pressure fuel injection pipe assemblies - General requirements and dimensions
Document Number
ISO 2974:2018
Revision Level
9TH EDITION
Status
Current
Publication Date
March 1, 2018
Committee Number
ISO/TC 22/SC 34