ISO-3302-1 › Rubber - Tolerances for products - Part 1: Dimensional tolerances
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 3302-1:2014 specifies classes of dimensional tolerances and their values for moulded, extruded, and calendared solid rubber products. The relevant test methods necessary for the establishment of compliance with ISO 3302-1:2014 are also specified.
The tolerances are primarily intended for use with vulcanized rubber but can also be suitable for products made of thermoplastic rubbers.
ISO 3302-1:2014 does not apply to precision toroidal sealing rings or to calendared composite products such as rubber-coated fabrics or products where a rubber coating is applied by the process of topping or skim coating.
To find similar documents by classification:
83.140.01 (Rubber and plastics products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC/EIA-J-STD-001
Requirements for Soldered Electrical and Electronic Assemblies
ASTM-A240
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
Document Number
ISO 3302-1:2014
Revision Level
2ND EDITION
Status
Current
Publication Date
July 15, 2014
Committee Number
ISO/TC 45/SC 4