ISO-3465 › Hand taper pin reamers
The following bibliographic material is provided to assist you with your purchasing decision:
Lays down only metric dimensions, which are the only recommended dimensions in the future for these types of reamers. The reamers habe been designed to produce holes for taper pins manufacured to ISO 2339 in the range 0,6 to 50 mm nominal diameter. Unless otherwise stated, these tools will be rigth-hand cutting. The flutes may be straight or spiral at the option of the manufacturer.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Aug. 15, 1975
ISO TC 29/SC 2