ISO-3508 › Thread run-outs for fasteners with thread in accordance with ISO 261 and ISO 262
ISO-3508
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Specifies for fully threaded screws with machined, or rolled threads pitches of the thread ranging from 0,2 mm to 6 mm and thread diameters (coarse thread) ranging from 1 mm to 68 mm; it does not apply to those threaded fasteners where special requirements are laid down in the product standards.
To find similar documents by classification:
21.060.01 (Fasteners in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3508:1976
Revision Level
1ST EDITION
Status
Current
Publication Date
Feb. 1, 1976
Committee Number
ISO TC 2/SC 7