ISO-3547-2 › Plain bearings - Wrapped bushes - Part 2: Test data for outside and inside diameters
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the test data for outside and inside diameters of wrapped bushes made of mono and multi-layer bearing material for plain bearing applications. It also specifies test designations.
Since the wall thickness of the bush is measured in the free condition, no special test data are required for this on the drawing (see ISO 3547 5 and ISO 3547 6).
NOTE Depending on the manufacturing method, the back of the bushes can show isolated light depressions and, similarly, bushes with lubrication holes, grooves and bore indentations can show distortion. It is therefore suggested to measure the wall thickness away from these areas.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A480Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
UL-94
Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
NFPA-13
Standard for the Installation of Sprinkler Systems
Document Number
ISO 3547-2:2023
Revision Level
4TH EDITION
Status
Current
Publication Date
June 1, 2023
Committee Number
ISO/TC 123/SC 3