ISO-3547-6 › Plain bearings - Wrapped bushes - Part 6: Checking the inside diameter
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
The document specifies, following ISO 12301, the checking of the inside diameter of wrapped bushes (see ISO 3547‑2:2017, method C) and describes the necessary checking methods and measuring equipment.
NOTE 1 All dimensions in this document are given in millimetres except where otherwise noted/designated.
NOTE 2 The dimensions and tolerances of wrapped bushes are given in ISO 3547‑1.
NOTE 3 Checking of the wall thickness is the subject of ISO 3547‑7.
NOTE 4 Checking of the outside diameter of wrapped bushes is the subject of ISO 3547‑5.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A480Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
UL-94
Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
NFPA-13
Standard for the Installation of Sprinkler Systems
Document Number
ISO 3547-6:2020
Revision Level
2ND EDITION
Status
Current
Publication Date
May 1, 2020
Committee Number
ISO/TC 123/SC 5