ISO-4126-9 › Safety devices for protection against excessive pressure - Part 9: Application and installation of safety devices excluding stand-alone bursting disc safety devices
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 4126-9:2008 covers the application and installations of safety devices such as safety valves, safety valves and bursting disc safety devices in combination, pilot-operated safety valves and controlled safety pressure-relief systems for the protection of pressure equipment. ISO 4126-6 covers the selection, application and installation of bursting disc safety devices.
ISO 4126-9:2008 describes the normative requirements for applications and installations of safety devices to protect static pressure equipment. The information contained in ISO 4126-9:2008 assumes single-phase flow of the fluid discharged from the safety device. ISO 4126-10 provides guidance specific to two-phase flow conditions.
Equipment connected together in a system by piping of adequate capacity, which is free from potential blockages and does not contain any valve that can isolate any part, can be considered to be a safety system for the application of pressure relief.
ISO 4126-9:2008 does not deal with other safety devices, such as safety related monitoring, control and regulation devices and other limiting devices allowed by some national regulations.
To find similar documents by classification:
13.240 (Protection against excessive pressure Including safety valves, bursting disc devices, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 4126-9:2008
Revision Level
1ST EDITION
Status
Current
Publication Date
April 15, 2008
Committee Number
ISO/TC 185