ISO-4633 › Historical Revision Information
Rubber seals - Joint rings for water supply, drainage and sewerage pipelines - Specification for materials
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies requirements for materials used in vulcanized rubber seals for
- cold drinking-water supplies (up to 50 °C);
- drainage, sewerage and rainwater systems (continuous flow up to 45 °C and intermittent flow up to 95 °C).
The different designations of seals specified are defined according to their type, application and requirements.
General requirements for finished joint seals are also given: any additional requirements called for by the particular application are specified in the relevant product standards, taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design. This International Standard is intended to be used where appropriate with product standards which specify performance requirements for joints.
This International Standard is applicable to joint seals for all pipeline materials, including iron, steel, clay, fibre cement, concrete, reinforced concrete, plastics and glass-reinforced plastics.
It is applicable to elastomeric components of composite or non-composite seals. In the case of composite seals for materials of hardness ranges from 76 IRHD to 95 IRHD, the requirements for elongation at break, compression set and stress relaxation apply only when the material is participating in the sealing function or in the long-term stability of the seal.
Joint seals made with an enclosed void as part of their design are included in the scope of this International Standard.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Sept. 15, 1996
ISO/TC 45/SC 4