ISO-6803 › Rubber or plastics hoses and hose assemblies - Hydraulic-pressure impulse test without flexing
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6803:2017 describes hose impulse testing, without flexing, of rubber or plastics hydraulic hose assemblies at both high and low impulse pressures. The high-pressure testing is carried out at pressures greater than 3 MPa and the low-pressure testing at pressures from 1,5 MPa to 3 MPa. The test procedure is applicable to hydraulic hose assemblies that are subject to pulsating pressures in service which are included in the product requirements.
NOTE Impulse test procedures with flexing can be found in ISO 6802.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6803:2017
Revision Level
4TH EDITION
Status
Current
Publication Date
March 1, 2017
Committee Number
ISO/TC 45/SC 1