ISO-683-2 Historical Revision Information
Heat-treatable steels, alloy steels and free-cutting steels - Part 2: Alloy steels for quenching and tempering

ISO-683-2 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 683-2:2012 specifies the technical delivery requirements for semi-finished products, hot formed (e.g. blooms, billets, slabs), bars, wire rod, finished flat products and hammer or drop forgings manufactured from the direct-hardening alloy steels and the alloy flame and induction hardening steels listed (in Table 3) and supplied in one of the heat-treatment conditions given for the different types of products (in Table 1) and in one of the surface conditions given (in Table 2).

The steels are, in general, intended for the manufacture of quenched and tempered or austempered and flame- or induction-hardened machine parts.

The requirements for mechanical properties given in ISO 683-2:2012 are restricted to the sizes given (in Table 8).

In addition to ISO 683-2:2012, the general technical delivery requirements of ISO 404 are applicable.

ORDER

To find similar documents by classification:

77.140.10 (Heat-treatable steels)

77.140.20 (Stainless steels Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc.)

77.140.45 (Non-alloyed steels)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 683-2:2012

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Sept. 15, 2012

Committee Number

ISO/TC 17/SC 4