ISO-7633 Road vehicles - Elastomeric boots for drum type hydraulic brake wheel cylinders using a petroleum base hydraulic brake fluid (service temperature 120 degrees C max.)

ISO-7633 - 1ST EDITION - CURRENT


Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


Specifies performance tests for moulded rubber boots used as end closures on drum type brake cylinders. These boots prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation. Applies to boots of both plain and reinforcement insert types. Requirements relating to chemical composition, tensile strength or elongation at break of the rubber compound are not included.

ORDER

Price:

$52.38        


Want this as a site license?

To find similar documents by classification:

43.040.40 (Braking systems)

83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 7633:1985

Revision Level

1ST EDITION

Status

Current

Publication Date

Aug. 15, 1985

Committee Number

ISO TC 22/SC 2/WG 3