ISO-8741 Grooved pins - Half-length reverse-taper grooved

ISO-8741 - 2ND EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This International Standard specifies the characteristics of half-length reverse taper grooved pins made of steel or austenitic stainless steel which have three equally spaced grooves impressed longitudinally on their exterior surface, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive.

The displaced material to each side of the grooves forming an expanded diameter d2 which is larger than the nominal diameter d1 will cause a non-positive locking fit when these grooved pins are forced into a drilled hole equal to the nominal diameter d1 (see clause 4).

ORDER

Price:

$52.38        


Want this as a site license?

To find similar documents by classification:

21.060.50 (Pins, nails)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 8741:1997

Revision Level

2ND EDITION

Status

Current

Publication Date

Nov. 1, 1997

Committee Number

ISO TC 2/WG 10