ISO-898-7 › Mechanical properties of fasteners - Part 7: Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm
ISO-898-7
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Applies to bolts and screws of property classes 8.8 to 12.9 in accordance with ISO 898-1 with thread less than M3 for which no breaking and proof loads are indicated in ISO 898-1, as well as to short bolts and screws with nominal diameters 3 mm to 10 mm which cannot be subjected to a tensile test. The minimum breaking torques are not valid for hexagon socket set screws.
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A484Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials
AMS-2759/1
Heat Treatment of Carbon and Low-Alloy Steel Parts, Minimum Tensile Strength Below 220 ksi (1517 MPa)
Document Number
ISO 898-7:1992
Revision Level
1ST EDITION
Status
Current
Publication Date
Nov. 1, 1992
Committee Number
ISO TC 2/SC 1