ISO-8986-1 › Plastics - Polybutene-1 (PB-1) moulding and extrusion materials - Part 1: Designation system and basis for specifications
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 8986-1:2009 establishes a system of designation for polybutene‑1 (PB‑1) thermoplastic materials which may be used as the basis for specifications.
The types of polybutene plastics are differentiated from each other by a classification system based on appropriate levels of the designatory property melt volume-flow rate and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
ISO 8986-1 is applicable to all butene homopolymers and to copolymers of butene with a maximum content of other 1‑olefinic monomers of less than 50 % by mass and with a content of non-olefinic monomers with functional groups up to a maximum of 1 % by mass.
It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 8986-1:2009
Revision Level
2ND EDITION
Status
Superseded
Publication Date
Nov. 15, 2009
Committee Number
ISO/TC 61/SC 9