ISO/IEC-7811-1 › Identification cards - Recording technique - Part 1: Embossing
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This document is one of a series of International Standards describing the parameters for identification cards as defined in the terms and definitions clause and the use of such cards for international interchange.
This document specifies requirements for embossed characters on identification cards. The embossed characters are intended for transfer of data either by use of imprinters or by visual or machine reading. It takes into consideration both human and machine aspects and states minimum requirements.
It is the purpose of this document to provide criteria to which cards shall perform. No consideration is given within this document to the amount of use, if any, experienced by the card prior to test. Failure to conform to specified criteria is negotiated between the involved parties.
ISO/IEC 10373‑1 specifies the test procedures used to check cards against the parameters specified in this document.
NOTE 1 Numeric values in the SI and/or Imperial measurement system in this document may have been rounded off and are consistent with, but not exactly equal to each other. Using either system is correct but intermixing or reconverting values can result in errors. The original design was made using the Imperial measurement system.
NOTE 2 Tactile Identifier Mark (TIM) defined by ISO/IEC 7811‑9 can be located in the name and address area of this document. The layout of embossed characters in this area is not intended to interfere with TIM.
To find similar documents by classification:
To find similar documents by Federal Supply Class Code:
FSC Standardization Area FACR (Facilities Engineering and Design Requirements)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ISO/IEC-7816-2Identification cards - Integrated circuit cards - Part 2: Cards with contacts - Dimensions and location of the contacts
ISO/IEC-7811-2
Identification cards - Recording technique - Part 2: Magnetic stripe: Low coercivity
ISO/IEC-7810
Identification cards - Physical characteristics
Document Number
ISO/IEC 7811-1:2018
Revision Level
5TH EDITION
Status
Current
Publication Date
Aug. 1, 2018
Committee Number
ISO/IEC JTC 1/SC 17