SIS-CEN/TR-196-4 › Methods of testing cement - Part 4: Quantitative determination of constituents
SIS-CEN/TR-196-4
-
2007 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Technical Report describes procedures for determining the contents of most of the constituents of the cements that fall within the scope of EN 197-1. In principle, the method described in Clause 6 applies to all cements, whatever the number and nature of their constituents, but in practice is limited to the cements identified in Table 1. The method in clause 6 should be considered to be the method of choice and is based on a sequential selective dissolution of the cementÂ’s constituents, generally of an unknown number, where they are not available separately for analysis at the same time as the cement. The method of choice enables the quantitative determination (by mass) of: Portland cement clinker, blastfurnace slag, siliceous fly ash, natural pozzolans, limestone, silica fume and set regulators in cements of the types identified in Table 1. Table 1 is derived from Table 1 of EN 197-1.
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SIS-CEN/TR 196-4:2007
Revision Level
2007 EDITION
Status
Current
Publication Date
Oct. 8, 2007
Language(s)
English
Page Count
44