SS-EN-1007-6 › Advanced technical ceramic - Ceramic composites - Methods of test for reinforcements - Part 6: Determination of tensile properties of filaments at high temperature
SS-EN-1007-6
-
2007 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the conditions for measurement of tensile properties a of single filament of ceramic fibres at high temperatures in air or inert atmosphere (vacuum or controlled atmosphere). The method applies to continuous ceramic filaments taken from tows, yarns, staple fibre, braids and knitting, that have strain to fracture less than or equal to 5 % and show linear elastic behaviour to fracture. The method does not apply to testing for homogeneity of strength properties of fibres, nor does it assess the effects of volume under stress. Statistical aspects of fibre failure are not included. Two methods are proposed depending on the temperature of the filament end: - Hot end method: this method allows determination of tensile strength, of Young's modulus and of the stress strain curve. NOTE 1 Current experience with this technique is limited to 1 300 °C, because of the application temperature of ceramic glue. - Cold end method. NOTE 2 This method is limited to 1 700 °C in air and 2 000 °C in inert atmosphere because of the limits of furnaces.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1007-6:2007
Revision Level
2007 EDITION
Status
Current
Publication Date
Dec. 6, 2007
Language(s)
English
Page Count
40
International Equivalent
EN 1007-6:2007(IDT)