Document Center is acquired by Nimonik

This document applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm and in thicknesses equal to or less than 3 mm, delivered in sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet. It does not apply to cold rolled narrow strip (rolling width < 600 mm) or to cold rolled flat products for which there is a specific standard, in particular the following: — cold-rolled low carbon steel flat products for cold forming (EN 10130); — cold-rolled non-oriented electrical steel sheet and strip delivered in fully processed state (EN 10106); — cold rolled electrical non-alloy and alloy steel sheet and strip delivered in the semi-processed state (EN 10341); — cold reduced blackplate (EN 10205); — steel sheet and strip for welded gas cylinders (EN 10120); — cold-rolled uncoated non-alloy mild steel narrow strip for cold forming (EN 10139); — cold-rolled structural steels for general purposes; — cold-rolled flat products made of high yield strength for cold forming (EN 10268).