SS-EN-10246-14 › Non-destructive testing of steel tubes - Part 14: Automatic ultrasonic testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of laminar imperfections
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This Part of EN 10246 specifies requirements for automatic ultrasonic testing of seamless and welded steel tubes, with the exception of submerged arc welded (SAW) tubes, for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures. NOTE : An alternative test method for the detection of laminar imperfections in steel strip/plate prior to tube forming of welded tubes, is given in EN 10246-15. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter greater than 30 mm. No lower limit of wall thickness is specified but see note in 4.1. European Standard EN 10246 "Non-destructive testing of steel tubes" comprises the parts shown in Annex A.
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 10246-14
Revision Level
EDITION 1
Status
Superseded
Publication Date
Dec. 17, 1999
Language(s)
English
Page Count
13