SS-EN-10341 › Cold rolled electrical non-alloy and alloy steel sheet and strip delivered in the semi-processed state
SS-EN-10341
-
2006 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies cold-rolled electrical non-oriented non-alloy1) or alloy2) steel sheet and strip delivered in nominal thicknesses of 0,50 mm and 0,65 mm in the semi-processed condition, that is without final heat treatment; in particular, it specifies general requirements, magnetic properties, geometric characteristics and tolerances and technological characteristics, as well as the inspection procedure. This document applies to material intended for the construction of magnetic circuits. These magnetic materials correspond respectively to subclauses C21 and B2 of IEC 60404-1:2000. 1) Non-alloy steel is that steel the basic constituent of which is iron containing alloying elements in amounts smaller than the limiting values fixed by EN 10020. 2) Alloy steel is that steel the basic constituent of which is iron containing alloying elements in amounts equal to or greater than the limiting values fixed by EN 10020.
To find similar documents by classification:
29.030 (Magnetic materials Steels with special magnetic properties, see 77.140.40)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 10341:2006
Revision Level
2006 EDITION
Status
Current
Publication Date
June 1, 2006
Language(s)
English
Page Count
19