SS-EN-1114-2 › Plastics and rubber machines - Extruders and extrusion lines - Part 2: Safety requirements for die face pelletisers
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies safety requirements for the design and construction, in respect of the hazards listed in clause 4 and dealt with in clause 5, of the following kinds of die face pelletisers used with extruders for pelletising of plastics and rubber: -- Underwater pelletisers; -- Water ring pelletisers; -- Dry pelletisers; -- Centrifugal pelletisers; -- Knife rotor pelletisers. Strand pelletisers are not subject to this standard. They are dealt with in a separate standard being produced by CEN/TC 145/WG6. This standard does not cover requirements for the design of any exhaust system. This standard applies to machines which are manufactured after the date of publication by CEN of the standard.
To find similar documents by classification:
83.200 (Equipment for the rubber and plastics industries)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1114-2+A1:2008
Revision Level
1998/A1 EDITION
Status
Superseded
Publication Date
Sept. 22, 2008
Language(s)
English
Page Count
32
International Equivalent
EN 1114-2:1998+A1:2008(IDT)