SS-EN-1114-2+A1 Plastics and rubber machines - Extruders and extrusion lines - Part 2: Safety requirements for die face pelletisers

SS-EN-1114-2+A1 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This European Standard specifies safety requirements for the design and construction, in respect of the hazards listed in clause 4 and dealt with in clause 5, of the following kinds of die face pelletisers used with extruders for pelletising of plastics and rubber: -- Underwater pelletisers; -- Water ring pelletisers; -- Dry pelletisers; -- Centrifugal pelletisers; -- Knife rotor pelletisers. Strand pelletisers are not subject to this standard. They are dealt with in a separate standard being produced by CEN/TC 145/WG6. This standard does not cover requirements for the design of any exhaust system. This standard applies to machines which are manufactured after the date of publication by CEN of the standard.

To find similar documents by classification:

83.200 (Equipment for the rubber and plastics industries)

ORDER



Designation Name

SS-EN 1114-2+A1:2008

Revision Level

2008 EDITION

Status

Superseded

Publication Date

Sept. 22, 2008

Language(s)

English

Page Count

32

International Equivalent

EN 1114-2:1998+A1:2008(IDT)