SS-EN-12012-2+A2 Plastics and rubber machines - Size reduction machines - Part 2: Safety requirements for strand pelletisers

SS-EN-12012-2+A2 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This standard specifies the essential safety requirements applicable to the design and construction of strand pelletisers used for plastics and rubber and fed continuously by an extruder or a reactor. The machine begins with the feed opening of the feeding device, or start-up devices if fitted, and ends with the discharge area. Only the significant hazards listed in clause 4 and dealt with in clause 5 are subject to this standard. NOTE Directive 94/9/EC concerning equipment and protective systems intended for use in potentially explosive atmospheres can be applicable to the type of machine or equipment covered by this European Standard. The present standard is not intended to provide means of complying with the essential health and safety requirements of Directive 94/9/EC. This standard applies to machines which are manufactured after the date of approval of this standard by CEN.

To find similar documents by classification:

83.200 (Equipment for the rubber and plastics industries)

ORDER



Designation Name

SS-EN 12012-2+A2:2008

Revision Level

2008 EDITION

Status

Superseded

Publication Date

Sept. 22, 2008

Language(s)

English

Page Count

32

International Equivalent

EN 12012-2:2001+A2:2008(IDT)