SS-EN-12012-3 Plastics rubber machines - Size reduction machines - Part 3: Safety requirements for shredders

SS-EN-12012-3 - 2001/A1 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This standard specifies the essential safety requirements applicable to the design and construction of shredders used for plastic and rubber. The machine begins with the outer edge of the feed hopper and ends with the discharge area. This standard does not deal with equipment for feeding material or discharging shredded material. This standard does not deal with safety measures to reduce the risk from ignition of flammable residues in material to be shredded This standard does not deal with requirements for local exhaust ventilation systems. Only the significant hazards listed in clause 4 and dealt with in clause 5 are subject to this standard. NOTE Directive 94/9/EC concerning equipment and protective systems intended for use in potentially explosive atmospheres can be applicable to the type of machine or equipment covered by this European Standard. The present standard does not necessarily comply with Directive 94/9/EC. Additional safety requirements in a future revision of this standard may be necessary to satisfy Directive 94/9/EC. This standard applies to machines which are manufactured after the date of approval of this standard by CEN.

To find similar documents by classification:

83.200 (Equipment for the rubber and plastics industries)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.


Designation Name

SS-EN 12012-3+A1:2008

Revision Level




Publication Date

Sept. 22, 2008



Page Count


International Equivalent

EN 12012-3:2001+A1:2008(IDT)