SS-EN-12158-2 Builders' hoists for goods - Part 2: Inclined hoists with non-accessible load carrying devices

SS-EN-12158-2 - 2001/A1 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

1.1 This standard deals with power operated temporarily installed builders hoists intended for use by persons who are permitted to enter sites of engineering and construction, serving either one upper landing or a work area extending to the end of the guides, (e.g. a roof) having a load carrying device (lcd): - which is intended for the transportation of goods only; - where it is forbidden for persons to step upon it at any time; - which is guided; - which is designed to travel at an angle of at least 30 degrees to the vertical but may be used at any angle between the vertical and the maximum inclination as specified by the manufacturer; - which is sustained by steel wire rope and a positive drive system; - which is controlled by hold-to-run controls by the operator; - which does not benefit from the use of any counterweight; - which has a maximum rated load of 300 kg; - which has a maximum speed of 1,00 m/s; and where the guides require support from separate structures. 1.2 The standard identifies hazards as listed in clause 4, which arise during the various phases in the life of such equipment and describes methods for the elimination or reduction of these hazards when used as intended by the manufacturer.

To find similar documents by classification:

91.140.90 (Lifts. Escalators)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 12158-2+A1:2010

Revision Level




Publication Date

Aug. 5, 2010



Page Count


International Equivalent

EN 12158-2:2000+A1:2010(IDT)