SS-EN-1218-1+A1 Safety of woodworking machines - Tenoning machines - Part 1: Single end tenoning machines with sliding table

SS-EN-1218-1+A1 - 2009 EDITION - CURRENT

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This document specifies all significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to single end tenoning machines with sliding table, hereinafter referred to as “machines”, designed to cut solid wood, chipboard, fibreboard, plywood and also these materials where they are covered with plastic laminate or edgings.This standard does not apply to: a) machines where the tenon is produced only by means of saw blades; b) machines where the design speed of any tool spindle exceeds 6000 min-1; c) machines where the average sliding table feed speed in either direction exceeds 25 m min-1 + 5%; d) combined machines used for tenoning (see EN 940:2009e) tenoning attachments on a vertical spindle moulding machine (see EN 848-1:2007NOTE Single and double end tenoning machines fed by chain or chains are dealt with in EN 1218-2. Single end tenoning machines where the tenon is produced only by means of saw blades are dealt with in EN 1218-3. This European Standard is primarily applicable to machines which are manufactured after the date of issue of his standard.

To find similar documents by classification:

79.120.10 (Woodworking machines Chain- and brush-saws, see 65.060.80)

Machinery. In vitro diagnostic medical devices. Revised Machinery Directive

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 1218-1+A1:2009

Revision Level




Publication Date

Sept. 7, 2009



Page Count


International Equivalent

EN 1218-1:1999+A1:2009(IDT)