SS-EN-12373-16 Aluminium and aluminium alloys - Anodizing - Part 16: Check for continuity of thin anodic oxidation coatings - Copper sulfate test

SS-EN-12373-16 - EDITION 1 - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This Part of this European Standard specifies a method of checking the continuity of thin anodic oxidation coatings on aluminium and its alloys by a copper sulfate contact test. The use of this method is limited to anodic oxidation coatings of less than 5 um thickness, or coatings that have been deformed. NOTE The method described enables a rapid check to be made for the continuity of a thin coating of aluminium oxide on aluminium and its alloys. In cases of doubt regarding a visible fault on the surface of a coating, the use of this method makes it possible to verify whether the fault corresponds to a local gap in the coating which exposes bare metal.

To find similar documents by classification:

25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)

77.120.10 (Aluminium and aluminium alloys)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 12373-16

Revision Level

EDITION 1

Status

Superseded

Publication Date

June 8, 2001

Language(s)

English

Page Count

7

International Equivalent

EN 12373-16:2001 IDT