SS-EN-124-1 › Gully tops and manhole tops for vehicular and pedestrian areas - Part 1: Definitions, classification, general principles of design, performance requirements and test methods
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard is applicable to manhole tops and gully tops with a clear opening up to and including 1 000 mm for covering gullies, manholes and inspection chambers installed in areas subjected to pedestrian and/or vehicular traffic. It specifies definitions, classification, general principles of design, performance requirements and test methods for gully tops and manhole tops according to: - EN 124 2, for gully tops and manhole tops made of cast iron; - EN 124 3, for gully tops and manhole tops made of steel or aluminium alloy; - EN 124 4, for gully tops and manhole tops made of steel reinforced concrete; - EN 124 5, for gully tops and manhole tops made of composite materials; - EN 124 6, for gully tops and manhole tops made of polypropylene (PP), polyethylene (PE) or unplasticized poly(vinyl chloride) (PVC-U). Part 1 is only applicable in combination with at least one of the standards EN 124 2, EN 124 3, EN 124 4, EN 124 5 and EN 124 6 each of which has this Part 1 as an integral part. This European Standard is not applicable to: - gratings/covers as part of prefabricated drainage channels according to EN 1433, - floor and roof gullies in buildings which are specified in EN 1253 1, - surface boxes.
To find similar documents by classification:
93.080.30 (Road equipment and installations Including road traffic warning and control systems, devices and installations (speed controls, traffic signal installations, vehicle loop detectors, pavement markers, manholes, etc.))
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
June 14, 2015