SS-EN-1301-3 › Aluminium and aluminum alloys - Drawn wire - Part 3: Tolerances on dimensions
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the tolerances on dimensions of aluminium and aluminium alloy drawn wire for general engineering applications (except aeronautical applications), covering diameters, thicknesses or widths or width across flats up to and including 20 mm. It applies to drawn wires, except for electrical or welding purposes. It does not apply to drawing stock.
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1301-3:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
Sept. 25, 2008
Language(s)
English
Page Count
16
International Equivalent
EN 1301-3:2008(IDT)