SS-EN-13104 Railway applications - Wheelsets and bogies - Powered axles - Design method

SS-EN-13104 - 2009/A2 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This standard: ? defines the forces and moments to be taken into account with reference to masses, traction and braking conditions; ? gives the stress calculation method for axles with outside axle journals; ? specifies the maximum permissible stresses to be assumed in calculations for steel grade EA1N defined in EN 13261; ? describes the method for determination of the maximum permissible stresses for other steel grades; ? determines the diameters for the various sections of the axle and recommends the preferred shapes and transitions to ensure adequate service performance. This standard is applicable to: ? solid and hollow powered axles for railway rolling stock; ? solid and hollow non-powered axles of motor bogies; ? solid and hollow non-powered axles of locomotives ; ? axles defined in prEN 13261; ? all gauges . This standard is applicable to axles fitted to rolling stock intended to run under normal European conditions. Before using this standard, if there is any doubt as to whether the railway operating conditions are normal, it is necessary to determine whether an additional design factor has to be applied to the maximum permissible stresses. The calculation of wheelsets for special applications (e.g. tamping/lining/levelling machines) may be made according to this standard only for the load cases of free-running and running in train formation. This standard does not apply to workload cases. They are calculated separately. For light rail and tramway applications, other standards or documents agreed between the customer and supplier may be applied.

To find similar documents by classification:

01.075 (Character symbols Standards included in this group shall also be included in other groups and/or sub-groups according to their subject)

45.040 (Materials and components for railway engineering)

45.060.01 (Railway rolling stock in general)


Infrastructure TSI for the trans-European high speed rail system dated 20 December 2007

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 13104:2009+A2:2012

Revision Level

2009/A2 EDITION

Status

Superseded

Publication Date

Nov. 6, 2012

Language(s)

English

Page Count

56

International Equivalent

EN 13104:2009+A2:2012(IDT)