SS-EN-13244-5 Plastics piping systems for buried and above-ground pressure systems for water for general purposes, drainage and sewerage - Polyethylene (PE) - Part 5: Fitness for purpose of the system

SS-EN-13244-5 - EDITION 1 - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This Part of EN 13244 specifies the characteristics of the fitness for purpose of the assembled piping systems intended for buried and above-ground pressure systems for water for general purposes, drainage and sewerage. It is also applicable for vacuum sewer systems. NOTE 1 Water for general purposes is not intended for human consumption and components conforming to this standard should not be used in systems conveying water for human consumption. For PE components intended for the conveyance of water intended for human consumption and raw water prior to treatment, see EN 12201 [5] . It also specifies the test parameters for the test methods referred to in this standard. In conjunction with other Parts of EN 13244 (see Foreword), it is applicable to PE pipes, fittings, valves, their joints and to joints with components of other materials intended to be used as follows: -- buried in the ground; -- sea outfalls; -- laid in water; -- above-ground, including pipes suspended below bridges; -- a maximum operating pressure, MOP, up to and including 25 bar; -- an operating temperature of 20 °C as a reference temperature. NOTE 2 For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see annex A of EN 13244-1:2002. EN 13244 covers a range of maximum operating pressures and gives requirements concerning colours and additives. NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national guidance or regulations and installation practices or codes.

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 13244-5

Revision Level

EDITION 1

Status

Superseded

Publication Date

Jan. 24, 2003

Language(s)

English

Page Count

13

International Equivalent

EN 13244-5:2002 IDT