SS-EN-1366-13 › Fire resistance tests for service installations - Part 13: Chimneys
SS-EN-1366-13
-
2019 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies a procedure to determine the fire resistance time for chimney constructions (see normative references), shafts of chimneys or penetration elements as part of a chimney construction under standardized fire conditions. The test examines the behaviour of chimney products exposed to fire only from the outside or fire from the outside entering into the chimney. This standard is used in conjunction with EN 1363-1. In chimneys combustion air supply ducts can also be included. The standard also applies to such chimneys. Slanted chimneys are not included. Annex A provides general guidance and background information. This document is not applicable to: sootfire resistance conditions; accessories unless they are included in the system chimney to be tested; one, two or three sided enclosures. If the pressure inside the chimney can in practice decrease to lower values than - 40 Pa or increase to higher values than + 5000 Pa it shall be considered that this cannot be covered by the test prescribed in this standard.
To find similar documents by classification:
13.220.50 (Fire-resistance of building materials and elements)
91.060.40 (Chimneys, shafts, ducts Including flues and flue pipes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1366-13:2019
Revision Level
2019 EDITION
Status
Current
Publication Date
May 2, 2019
Language(s)
English
Page Count
36
International Equivalent
EN 1366-13:2019(IDT)