SS-EN-14022 Structural Adhesives - Determination of the pot life (working life) of multi-component adhesives

SS-EN-14022 - 2010 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This European Standard specifies means of determining in appropriate ways the variable property known alternatively as useable working life and pot life. This European Standard specifies five methods for the determination of the time available for use, each of which is related to specific circumstances; particularly important being the rheology of the adhesive concerned and its rate of reaction. This European Standard can also be used for assessing non-structural adhesives. NOTE EN 302-7 could also be used for the determination of working life of adhesives for load-bearing timber structures. Because of the different properties of the individual multi-component systems, like rheology or viscosity, respectively velocity of hardening, etc., not all methods can be applied to each multi-component system with the same suitability. SAFETY STATEMENT— Persons using this document should be familiar with the normal laboratory practice, if applicable. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any regulatory conditions. ENVIRONMENTAL STATEMENT — It is understood that some of the material permitted in this standard may have negative environmental impact. As technological advantages lead to acceptable alternatives for these materials, they will be eliminated from this standard to the extent possible. At the end of the test, the user of the standard should take care to carry out an appropriate disposal of the wastes, according to local regulation.

To find similar documents by classification:

83.180 (Adhesives Including adhesive tapes Adhesive tapes for electrical insulation purposes, see 29.035.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 14022:2010

Revision Level

2010 EDITION

Status

Superseded

Publication Date

Feb. 22, 2010

Language(s)

English

Page Count

24

International Equivalent

EN 14022:2010(IDT)