SS-EN-14638-3 › Transportable gas cylinders - Refillable welded receptacles of a capacity not exceeding 150 litres - Part 3: Welded carbon steel cylinders made to a design justified by experimental methods
SS-EN-14638-3
-
2010 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
2010 EDITION - Sept. 7, 2010
2010 EDITION CORRIGENDUM 1 - March 12, 2012
2010 EDITION CORRIGENDUM 1 - March 12, 2012
This European Standard specifies minimum requirements concerning material, design, construction and workmanship, procedures and tests at manufacture of refillable transportable welded cylinders made of carbon steel, justified by experimental methods, of water capacities from 0,5 l up to and including 150 l for compressed or liquefied gases and of a test pressure up to 90 bar. NOTE This European Standard may also be used as a guideline for cylinders less than 0,5 l water capacity. This European Standard is primarily intended for industrial gases other than LPG but may also be applied for LPG. However, for dedicated LPG cylinders see EN 14140 [5], prepared by CEN/TC 286.
To find similar documents by classification:
49.030.20 (Bolts, screws, studs)
Directve 2008/68/EC of the European Parliament and of the council of 24 September 2008 on the inland transport of the dangerous goods
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 14638-3:2010
Revision Level
2010 EDITION
Status
Current
Publication Date
Sept. 7, 2010
Language(s)
English
Page Count
48
International Equivalent
EN 14638-3:2010(IDT)