SS-EN-14886 › Plastics and rubber machines - Bandknife cutting machines for block foams - Safety requirements
SS-EN-14886
-
2008 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European standard applies to machines that are designed specifically to cut, split or peel block foams to commercially required shapes, using a single or double cut. All hazards listed in clause 4 are covered by this document. Cutting of block foams may be by: - vertical cutting; - horizontal cutting; - inclined cutting; - transverse cutting; - contour cutting; or - a combination of the above. The material to be cut may be supported or transported by: - a fixed table; - a shuttle table; - a conveyor; - a turntable; - rollers; - mandrel; or - a combination of the above. Cutting can be either manual or automatic. Cutting tools can be: - smooth-edged or toothed bandknives; - cutting wires. Movement of the cutting tool can be either oscillating or continuous in one direction.
To find similar documents by classification:
83.200 (Equipment for the rubber and plastics industries)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 14886:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
March 10, 2008
Language(s)
English
Page Count
92
International Equivalent
EN 14886:2008(IDT)