SS-EN-15061 › Safety of machinery - Safety requirements for strip processing line machinery and equipment
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document defines the general safety requirements of strip processing lines. This document applies to: Strip processing lines for treating metal strip, from coil take-over-point of the entry section (terminal equipment, see 3.2) through the process (processing and terminal equipment, see 3.3 and 3.2) up to the coil take-over-point of the exit section or interface to other lines (terminal equipment), see Figure 1. NOTE 1 The aforementioned processes can also occur in combination. If the aforementioned processes will be combined with processes which are not covered by the scope of this document, this document can be used as a guideline. NOTE 2 Thermo process equipment integrated in strip processing lines is covered by the EN 746 series. For dryers and ovens, in which flammable substances are released, EN 1539 applies. This document does not cover: thermo process equipment, e.g. in accordance with the EN 746 series; dryers and ovens in accordance with EN 1539; coil transporting system before coil take-over-point at the entry section and after coil take-over-point at the exit section, e.g. hook conveyors, overhead cranes, fork lift and railway trucks and other vehicles; acid regeneration plants; regeneration plants which are not integral part of the strip processing line; storage equipment for coils; rolling mill stands (i.e. skin pass and reduction stands) according to EN 15094; rollshop equipment; separate process technology (e.g. compressed air system, treatment of water and treatment of rolling lubricant); separate cleaning system for exhaust air; firefighting systems. NOTE 3 Protection of persons in case of using asphyxiant gases used in firefighting system is covered by this document, see Annex C. This document deals with foreseeable significant hazards, hazardous situations and events relevant to strip processing lines, when used as intended and under conditions of misuse which are reasonably foreseeable by...
To find similar documents by classification:
77.180 (Equipment for the metallurgical industry)
Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 15061:2022
Revision Level
2022 EDITION
Status
Current
Publication Date
March 16, 2022
Language(s)
English
Page Count
116
International Equivalent
EN 15061:2022(IDT)