SS-EN-17059 › Plating and anodizing lines - Safety requirements
SS-EN-17059
-
2018 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document describes all significant hazards, hazardous situations and events relating to plating and anodizing lines, when used as intended and in compliance with the foreseeable conditions of the manufacturer. In addition, procedures for testing and measuring safety requirements, marking of equipment and minimum operation requirements are specified. For reference to plating lines and anodizing lines the term plating line is used in this document. This document applies to the design and construction of plating lines and anodizing lines including its transporter systems for surface treatment of industrial products by means of inorganic or organic electrolytes or by means of other process chemistries. Plating lines and anodizing lines in terms of this standard are arrangements of process tanks for: - electrolytic treatment of work pieces (e.g. electrocleaning, passivation, electroetching, burnishing, electrolytic polishing and brightening, drying); - wet chemical treatment of work pieces (e.g. degreasing, passivation, chemical polishing, etching, pickling, blackening); - electrolytic and electro-less metal deposition, even on non-metallic work pieces made electrically conductive by corresponding treatment; - changing of substance composition on the surface of metallic work pieces e.g. burnishing, blackening, phosphatizing, chromating and; - anodizing (anodic oxidation); including rinsing tanks and the corresponding transporter equipment (e.g. transporter systems, handling gantry, bean, etc.), where the products are lifted in and out of tanks. This document distinguishes between the following types of plating lines: - Type 1: manual lines; - Type 2: semi-automatic lines; - Type 3: fully automatic lines. Furthermore, it specifies equipment marking and requirements on user information. This document does not deal with hazards resulting from plating linesparts above category 1 of PED (Pressure Equipment Directive). This document is not applicable...
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 17059:2018
Revision Level
2018 EDITION
Status
Current
Publication Date
June 14, 2018
Language(s)
English
Page Count
88
International Equivalent
EN 17059:2018(IDT)