SS-EN-1715-1 › Aluminium and aluminium alloys - Drawing stock - Part 1: General requirements and technical conditions for inspection and delivery
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies general requirements for drawing stock of aluminium and aluminium alloys delivered in the form of coils with a unit mass ranging between 1 t and 4 t and obtained by common industrial processes. It also specifies the technical conditions for inspection and delivery of these products. It applies to drawing stock intended for the following main fields of application: wires for general electrical purposes; wires for general mechanical uses; wires for brazing and welding and metal spraying; food packaging. The specific requirements to drawing stock for these applications are specified in EN 1715-2, EN 1715-3 and EN 1715-4. It does not apply to wires which are drawn, but only to drawing stock which is produced by hot-working. NOTE Three main methods exist for the manufacture of drawing stock: a) continuously cast rod (CCR): a section is cast continuously in the groove of a wheel, the groove being closed by an endless strip; the solid and still hot section is rolled in a multistand rolling mill to the required diameter; the drawing stock rod thus produced is wound continuously to form coils up to 4 t in mass; b) hot rolled rod (HRR):
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1715-1:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
April 21, 2008
Language(s)
English
Page Count
24
International Equivalent
EN 1715-1:2008(IDT)