SS-EN-17333-3 › Characterisation of one component foam - Part 3: Application
SS-EN-17333-3
-
2020 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies test methods for the evaluation of the application properties for moisture curing, self-curing activatable or water drying foams dispensed from single pressurized foam containers. This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this document to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. The following test methods are described: - Method 1 - Cutting time: This test method describes how to determine the hardening time of a dispended froth until it could be cut. - Method 2 - Tack free time: This test method describes how to determine the tack free time of a freshly foamed OCF. - Method 3 - Sagging: This test method describes how to evaluate the sagging behaviour and determine the biggest joint possible before dispensed froth slips off.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 17333-3:2020
Revision Level
2020 EDITION
Status
Current
Publication Date
March 25, 2020
Language(s)
English
Page Count
20
International Equivalent
EN 17333-3:2020(IDT)