SS-EN-2608 › Aerospace series - Installation and removal requirements for 8 degrees 30' adaptors, threaded, with lockring
SS-EN-2608
-
2005 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This standard specifies the installation and removal requirements for adaptors, threaded, with lockring for pipe couplings 8°30' according to EN 2603. This standard establishes an accurate procedure of adaptor installation, removal and reinstallation to ensure the repeatability of the installation operation and to ensure the effective compliance to sealing and locking requirements. The adaptor shown on all figures of this standard is given as an example for the 8°30' interface according to EN 2604. This procedure is used for adaptors 8°30', for nominal pressure up to 28 000 kPa to install the adapters according to EN 3248, EN 3270 and EN 3566.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 2608:2005
Revision Level
2005 EDITION
Status
Current
Publication Date
Dec. 16, 2005
Language(s)
English
Page Count
23