SS-EN-3916 › Aerospace series - Insert, thin wall - Salvage procedure for components
SS-EN-3916
-
2008 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This specification covers the accepted methods for the reclamation of installation holes for standard thin wall inserts, within assemblies. 1.2 To enable rectification when defects or damage occur to the standard insert tapped installation hole, or to rectify any out of position of the hole within the specified parameters of use. 1.3 To control the machining of the existing insert hole and the installation requirements of the replacement oversize thin wall insert.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 3916:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
Aug. 18, 2008
Language(s)
English
Page Count
24
International Equivalent
EN 3916:2008(IDT)