SS-EN-754-8 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 8: Porthole tubes, tolerances on dimensions and form

SS-EN-754-8 - 2016 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2), supplied in straight lengths. This document only applies to cold drawn tube for general engineering applications made in the following alloys:— EN AW-1050A, EN AW-1200; — EN AW-3003, EN AW-3103; — EN AW-5005, EN AW-5005A, EN AW-5049, EN AW-5251, EN AW-5052; — EN AW-6012, EN AW-6060, EN AW-6061, EN AW-6262, EN AW-6262A; — EN AW-6063, EN AW-6063A, EN AW-6065, EN AW-6082; — EN AW-7020.The temper designations used in this part are according to EN 515. This document only applies to tube produced by the porthole/bridge method of extrusion only (and then cold drawn to the final dimensions). This document does not apply to:— cold drawn tubes produced by the seamless, die/mandrel method (EN 754-7), — tubes delivered in coils (EN 13958), — coiled tubes cut to length (EN 13958).

To find similar documents by classification:

77.120.10 (Aluminium and aluminium alloys)

77.150.10 (Aluminium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$102.00        




Designation Name

SS-EN 754-8:2016

Revision Level

2016 EDITION

Status

Current

Publication Date

June 13, 2016

Language(s)

English

Page Count

28

International Equivalent

EN 754-8:2016(IDT)